A Halden company - serving Marietta, GA

Daikin Heat Pump Service Nationwide

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

Your new heating and cooling system for as low as$119/month*On approved credit; ask for current terms

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Daikin Heat Pump Service: The Marietta Owner’s Guide

We service Daikin heat pumps throughout Marietta with genuine OEM and quality aftermarket parts, and most repairs run between $150 and $650 installed. If your Daikin heat pump is blowing warm air, short-cycling, or freezing up, we can typically get a technician to your door the same day with the parts needed on the truck. The most common discovery path we hear from Marietta homeowners goes like this: the unit ran fine last spring, then Georgia humidity hit hard, and suddenly the outside unit sounds like a washing machine full of rocks or the thermostat reads 78 when it’s set to 72.

HVAC technician performing furnace repair and diagnostic testing on a heating system nationwide

Call (229) 514-0545

Halden Heating and Air Marietta is an independent service provider, not affiliated with Daikin. That matters because we stock parts across Daikin, Carrier, Trane, and Lennox and give you a straight answer on what failed, what it costs, and what’s actually worth fixing.

Which Daikin Models This Applies To

We service the full Daikin heat pump lineup, including the FIT, DZ, and VRV series, plus the older split systems that installers put into Cobb County homes over the past 15 years. The key to matching your part correctly is the model number on the data plate. On Daikin units, that plate usually sits on the side of the outdoor condenser near the service valves, and the model starts with a two-letter prefix like DZ, DX, or FT. Snap a photo of it before you call. It saves a trip.

One compatibility gotcha we see regularly in Marietta: Daikin inverter-driven heat pumps (the FIT series especially) use proprietary inverter boards rather than standard contactors. If a tech throws in a generic two-stage board and calls it good, the system will run rough or throw error codes within weeks. For inverter models, we always use the OEM Daikin part because the control logic is tuned to the compressor’s drive frequency. For simpler mechanical parts like capacitors, fan motors, and contactors on older DZ systems, a quality aftermarket equivalent often works well and costs less. We’ll tell you which route fits your unit before you spend a dollar.

Explore

Styles & brands we work with

AC repair
AC repair
Furnace & heating
Furnace & heating
Heat pumps
Heat pumps
Ductless mini splits
Ductless mini splits
Carrier
Carrier
Trane
Trane
Goodman
Goodman

Signs Your Daikin Heat Pump Service Is Failing

  • Outside unit runs but no cold air inside. This usually points to a failed compressor capacitor or a refrigerant leak. The capacitor is a cylinder on the side of the outdoor unit that gives the compressor its starting jolt. When it weakens in Marietta’s humidity cycles, the compressor hums but never fully starts. A leak means the refrigerant charge (the coolant that actually moves heat) has escaped somewhere in the line set.
  • The outside unit ices over in summer. Ice on the coil in July means low refrigerant, a clogged metering device, or a failing indoor blower motor. Daikin’s thin-fin coils are efficient but they ice fast when airflow drops. Letting it run iced up can slug the compressor with liquid refrigerant, which is a much bigger repair.
  • Weird noises from the outdoor unit. A grinding or rattling sound often means the fan motor bearings are shot or the blade is hitting a bent coil guard. A sharp buzzing with no fan movement is usually the contactor or capacitor. These are common Daikin failure points in our area because pine pollen and the wet spring season coat the coil and force the fan motor to work harder.
  • Unit short-cycles on and off every few minutes. On Daikin inverter systems, this can be a failing thermistor (a temperature sensor that tells the board what the coil is doing). On older single-stage units, it’s often an oversized system fighting a clogged filter. Short-cycling wastes power and wears out the compressor faster than anything else.
  • Electric bills climbing with no change in your thermostat habits. A Daikin heat pump that’s running 20% more because it’s low on charge or fighting a dirty coil will show up on your Cobb EMC or Georgia Power bill within two billing cycles. The heat pump is working, just not efficiently, and the extra runtime lands on the compressor’s lifespan.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Daikin heat pump service in Marietta, here’s what you can expect based on the part that failed:

  • Capacitor replacement: $150 – $350 installed, depending on whether it’s a single or dual-run capacitor and how accessible the outdoor unit is. This is the most common heat pump repair we do.
  • Contactor replacement: $180 – $400 installed. The contactor is the electrical switch that routes power to the compressor and fan. Marietta’s summer storms and power surges are hard on these.
  • Fan motor replacement: $300 – $600 installed. Daikin fan motors on newer units come as complete assemblies, which costs more but eliminates blade alignment issues.
  • Thermistor or sensor replacement: $200 – $450 installed. Requires opening the coil cabinet on most Daikin models, which adds labor time.
  • Refrigerant leak repair and recharge: $400 – $650 installed. Includes finding the leak, repairing it, pressure testing, and recharging to the factory spec on the data plate.

Every repair from Halden Heating and Air Marietta includes a written price before work starts, a written guarantee on the repair, and a free second visit if the repair fails within the coverage window. That’s not an add-on. It’s how every job runs.

HVAC technician performing furnace repair and diagnostic testing on a heating system nationwide

DIY or Call Us?

Honest answer: you can check a few things safely before calling. Confirm the thermostat is set to cool and the air filter isn’t caked with dust. Check the breaker at your panel and the disconnect box near the outdoor unit. If the outside coil is covered in leaves or pollen, you can gently rinse it with a garden hose (power off, water only, no pressure washer). Those fixes solve maybe 10% of the calls we run in Marietta.

What you should not do is open the electrical cabinet on a heat pump. Capacitors hold a charge even after the power is off, and the wrong move can send you to the ER. The same goes for refrigerant: Georgia requires an EPA 608 certification to handle it, and guessing at a leak is how you turn a $200 fix into a $2,000 compressor. If the unit is running but not cooling, or making noise, or icing up, call us at (229) 514-0545. We’ll get you a live arrival time and a technician who’s seen this exact failure on a Daikin before.

FAQs

Need HVAC help in Marietta? Licensed & insured · same-day response · free estimates
Call (229) 514-0545
Local Service Coverage

Request a Free Estimate in Marietta

Tell us what you need - Halden Heating and Air Marietta responds fast. No obligation.

By clicking submit, you agree to our Privacy Policy and agree to be contacted through phone, text, or email regarding your project, including by the service partners who may complete the work.

Prefer to text? Text Us
Call Now - 24/7 Dispatch