Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateDaikin AC Installation in Marietta: What to Know First
Daikin AC installation in Marietta typically runs between $3,500 and $7,500 depending on the model line, home size, and whether you’re replacing an existing system or installing from scratch. We’re an independent Daikin service provider, not a factory-authorized dealer, which means we give you straight answers about which Daikin units hold up in Georgia humidity and which ones cost more to run than they should. Most installations are completed in one day, with a written price locked in before we touch a single panel.

This page is for homeowners in Marietta who already own a Daikin system, are considering one, or have a contractor quoting them a Daikin install and want a second opinion from people who actually work on these units. Call (229) 514-0545 for a free estimate.
How Daikin Products Fail – and How We Fix Them
Daikin builds solid equipment, but every brand has its patterns. Here’s what we see on Daikin installs and replacements across Marietta, from older homes near the Square to newer builds in East Cobb:
- Daikin Fit systems and the condensate drainage issue. The Daikin Fit (DZ-series) is a side-discharge unit that sits low to the ground. In Marietta’s summer humidity, the factory drain routing can allow water to pool in the unit’s base pan if the pad settles even slightly. We install these with an elevated pad and a secondary drain line on every job. If you’ve got a Fit that’s pooling water, it’s not a defect – it’s an installation shortcut. Our fix is a re-level and drain reroute, usually doable in under two hours.
- Daikin ComfortNet thermostats losing communication with the air handler. On Daikin variable-speed systems (the DX and DZ series), the communicating thermostat sometimes drops its signal to the indoor unit after a power bump. The unit runs, but it runs at full speed or not at all because the modulating signal is gone. We see this a lot on older Marietta homes where the electrical panel isn’t grounded the way newer builds are. The fix is usually a firmware reset and re-pairing, not a new thermostat.
- Daikin inverter boards and Georgia’s thunderstorms. Daikin’s inverter-driven outdoor units are efficient, but the inverter board is sensitive to voltage fluctuations. Marietta gets real lightning season, and a nearby strike can scramble the board even through a surge protector. When we install Daikin inverters, we always recommend a dedicated surge protector wired at the disconnect. It’s a $150 – $300 add-on that has saved more than a few customers a $900+ board replacement.
- Multi-zone Daikin mini-splits with one zone not cooling. Daikin mini-splits (the Aurora and Emura lines) are popular for additions and sunrooms in Marietta. When one indoor head stops cooling while the others work, it’s almost always a refrigerant distribution issue at the branch box, not a bad head. The flare connections at the branch box can develop micro-leaks over time, especially if they were overtightened or undertightened at original installation. We pressure-test and re-flare those lines on every multi-zone install so you don’t get that failure two years in.
- Daikin gas furnace paired with a heat pump: the dual-fuel crossover setting. In Marietta, dual-fuel Daikin setups (heat pump outside, gas furnace inside) are a smart choice. But if the changeover temperature from heat pump to gas isn’t set correctly at installation, you’ll burn through gas at 40°F when the heat pump could handle it, or you’ll run the heat pump well below freezing and lose comfort. We set the crossover point based on your utility rates and the actual load, not the factory default. It’s a software setting most installers never touch.
Styles & brands we work with







Our Daikin AC Installation Process
Here’s what a Daikin install looks like when you call Halden Heating and Air Marietta:
- 1
Estimate with real numbers. You tell us what you’ve got, we come out and look at the space, and you get a written price for the full job – equipment, labor, permits, everything. No ballpark, no “plus whatever we find.”
- 2
Equipment decision (OEM vs. aftermarket). We walk you through Daikin OEM parts and where a quality aftermarket component makes more sense. New Daikin outdoor unit? OEM. Blower motor for a 12-year-old Daikin air handler? We’ll show you both options with prices and let you choose.
- 3
Install day: tracked arrival. You book online, get a live arrival time, and track your tech to the door. They’re uniformed, background-checked, and they know Daikin systems – not a trainee learning on your unit.
- 4
The install itself. We pull and reuse or replace the line set as needed, verify ductwork static pressure, set the charge by subcooling or superheat depending on the system, and program the thermostat for your schedule.
- 5
Testing and the 365-Day Done Right Promise. Before we leave, we run the system through its paces and take before-and-after photos. Every Daikin install we do is covered by the 365-Day Done Right Promise: if something’s not right within a year, we come back and fix it. Written guarantee, no arguing.
See the difference
Before
After
Before
After
Before
AfterWhat Daikin AC Installation Costs in Marietta
The $3,500 – $7,500 range covers most Daikin central air and heat pump installations in Marietta. What moves the number is the line you pick and what’s already in your house. Here’s how it breaks down:
- Daikin 14 SEER2 single-stage central AC (replacing existing): $3,500 – $4,500. A straightforward swap if your ductwork and electrical are sound.
- Daikin 16 – 17 SEER2 two-stage or variable-speed system: $4,500 – $6,000. Better humidity control for Marietta summers, quieter operation, lower long-run electric bills.
- Daikin inverter heat pump with gas backup (dual-fuel): $5,500 – $7,500. The top choice for efficiency, especially if your existing furnace is still in decent shape.
- Multi-zone Daikin mini-split (two to three heads): $5,000 – $7,000 depending on line set run lengths and wall access.
What moves the price: whether your ductwork needs sealing or repair, whether your electrical panel has room for the required breaker, and permit fees specific to Cobb County. Call (229) 514-0545 for an exact quote – estimates are free, and the price we quote is the price you pay.
Why Marietta Homeowners Call Halden Heating and Air Marietta for Daikin Work
We’re not the biggest HVAC shop in Cobb County, and we don’t want to be. We’re the one that answers the phone when it’s 9:30 PM and your Daikin just quit, the one that puts a price in writing before a wrench comes out, and the one that gives you a live arrival time you can track instead of a four-hour window. Every Daikin repair and install comes with a written guarantee. If a repair fails within the coverage period, we come back at no charge – automatically, not because you argued for it. That’s the 365-Day Done Right Promise, and it’s not a promotional offer. It’s how we’ve done business since Andre Fuller started this company. Straight answer, written price, done right.
We also service the brands sitting next to your Daikin in the driveway – Carrier, Trane, and Lennox units show up all over Marietta, and our techs are certified on all of them. If your Daikin can’t be saved or doesn’t make sense to repair, we’ll tell you that honestly and show you the math before you spend anything.
FAQs
No. As an independent Daikin service provider, we install Daikin equipment following the manufacturer’s installation specs exactly, and your factory warranty remains valid. Daikin’s warranty is tied to proper installation and registration, not to who sold you the unit. We register your equipment warranty on install day and keep a record in your file.
For a straightforward replacement, most Daikin installations are done within 3 to 7 days of your estimate, depending on equipment availability. Emergency replacements – when your AC is dead in July and you need it fixed now – get moved to the top of the queue. Call (229) 514-0545 and we’ll give you a real date, not a range.
If your Daikin is under 10 years old and the repair is under $650, repair it. If it’s over 12 years old, uses R-410A refrigerant (which is getting more expensive as it’s phased down), and the repair quote is north of $1,200, replace it. We’ll show you both numbers and let you decide – we don’t make commission pushing new equipment we don’t think you need.
For most homes in Marietta, yes. A Daikin inverter heat pump handles both cooling and moderate heating, and Georgia’s relatively mild winters mean the heat pump does most of the work while your gas furnace stays off. You’ll see the difference on your power bill, especially in spring and fall when the heat pump runs alone. The payback on the added upfront cost is typically 4 – 7 years depending on utility rates.
Yes. We install Daikin mini-splits, including the Aurora and Emura lines, for sunrooms, garages, additions, and older Marietta homes where running ductwork isn’t practical. Multi-zone setups are common for us, and we pressure-test every flare connection before charging the system so you don’t get a slow refrigerant leak two years down the road. Call (229) 514-0545 for a free estimate.
Need a Daikin AC installed, replaced, or just looked at by someone who’ll tell you the truth? Call Halden Heating and Air Marietta at (229) 514-0545 or book online. Written price before work starts. Live arrival time you can track. 365-Day Done Right Promise on every job.
Written by Andre Fuller, Owner, Halden Heating and Air Marietta at Halden Heating and Air Marietta, serving Marietta and nearby areas.