A Halden company - serving Marietta, GA

Rheem Heat Pump Service Nationwide

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

Your new heating and cooling system for as low as$119/month*On approved credit; ask for current terms

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Rheem Heat Pump Service: The Marietta Owner’s Guide

Rheem heat pump service in Marietta typically runs between $150 and $650 depending on which part failed, and most repairs are done same day when we have the component on the truck. If your Rheem heat pump is running but not heating or cooling properly, making strange noises, or cycling on and off every few minutes, you’re likely looking at a failed capacitor, contactor, defrost control board, or reversing valve – the four most common Rheem-specific failures we see across Cobb County. Here’s the straight answer: almost every Rheem heat pump issue is fixable without replacing the whole unit, and we’ll tell you the exact price before any work starts.

HVAC technician testing an air conditioning capacitor with a multimeter nationwide

Call (229) 514-0545

We’re an independent service provider, not affiliated with Rheem, but we service Rheem heat pumps across Marietta more weeks than any other brand. Andre Fuller, owner of Halden Heating and Air Marietta, spent the better part of two decades working on Rheem units before founding this company, and our trucks stay stocked with the Rheem-specific parts that fail most often in Georgia’s heat and humidity.

Which Rheem Models This Applies To

This covers Rheem’s residential heat pump lines commonly installed in Marietta homes: the RP14, RP15, RP16, RP17, RP18, and the two-stage RP20 series, plus the newer Endeavor and Prestige lines. The tricky part with Rheem is that a part number from an RP14 won’t necessarily fit an RP16 even if the units look identical from the outside. Rheem changed voltage requirements on some control boards between series, and capacitor specifications vary by model year even within the same series line.

The fastest way to identify your unit is the data sticker on the side or back panel of the outdoor condenser. You’ll see a model number starting with “RP” followed by digits, plus a serial number where the third and fourth digits tell you the manufacturing year. Snap a photo of that sticker before you call us. It saves a trip back to the truck and gets the right part in hand faster. For OEM Rheem parts versus quality aftermarket equivalents, here’s the honest breakdown: capacitors and contactors have solid aftermarket options from brands like AmRad and Mars that work just as well as OEM and cost less. But with Rheem defrost control boards and reversing valves, we won’t put aftermarket parts in your unit. Those boards control your system’s defrost cycle, and a cheap knockoff board can take out your compressor when it fails to defrost properly during a Marietta winter. That’s a $3500 repair from a $90 part decision. Straight answer: OEM for electronics, quality aftermarket okay for wear items.

Explore

Styles & brands we work with

AC repair
AC repair
Furnace & heating
Furnace & heating
Heat pumps
Heat pumps
Ductless mini splits
Ductless mini splits
Carrier
Carrier
Trane
Trane
Goodman
Goodman

Signs Your Rheem Heat Pump Service Is Failing

Here’s what we actually see on service calls around Marietta Square, East Cobb, and Kennesaw Mountain neighborhoods, and what each symptom points to:

  • Outdoor unit runs but no cold air inside. This usually means the compressor isn’t actually running. On Rheem units, a failed dual-run capacitor is the culprit roughly 7 out of 10 times. The capacitor gives the compressor the electrical jolt it needs to spin up, and Georgia’s heat burns through them faster than the manufacturer’s rated lifespan.
  • Unit short-cycles, clicking on and off every few minutes. The contactor, a heavy-duty relay switch, is failing. Marietta’s summer humidity causes contactor points to corrode and arc, and once they start sticking, your heat pump can’t hold a steady cooling cycle.
  • In heat mode, the unit ices over and won’t defrost. This points to the defrost control board or the defrost thermostat. Rheem’s defrost logic is board-based, and when that board goes, your outdoor coil freezes and the system shuts down to protect the compressor. We see this most in January and February when Marietta nights drop below 40.
  • System heats when it should cool, or cools when it should heat. The reversing valve, the part that swaps refrigerant direction, is stuck. A stuck reversing valve is one of the few repairs that can legitimately justify replacing an older Rheem unit, especially if the valve body itself has failed rather than just the solenoid coil.
  • Humming or buzzing noise from the outdoor unit that gets louder over time. That’s often a compressor struggling against a weak capacitor, or a failing compressor relay. If you hear it, shut the system off and call us. Running it longer turns a $200 capacitor replacement into a $3500 compressor replacement.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what Marietta homeowners actually pay for Rheem heat pump service, parts and labor included:

Rheem Part Typical Installed Cost in Marietta Typical Repair Time
Dual-run capacitor $150 – $250 30 – 60 minutes
Contactor $180 – $300 45 – 90 minutes
Defrost control board (OEM Rheem) $300 – $500 1 – 2 hours
Defrost thermostat/sensor $200 – $350 1 – 1.5 hours
Reversing valve replacement $350 – $650 2 – 4 hours

The range comes down to which Rheem series you have, how accessible the part is inside the unit, and whether your system needs a refrigerant recovery when we’re done. Every single job gets a written price before any work starts, not after we open the panel and “discover” something. The written guarantee on every repair means if the part fails within our coverage window, we come back and fix it at no charge. That’s automatic, not an add-on, and it’s covered under the 365-Day Done Right Promise.

DIY or Call Us?

Here’s the honest split. You can safely check two things yourself: first, that your thermostat is actually calling for heat or cool, and second, that your breaker hasn’t tripped. That’s it. Inside that Rheem cabinet is 240 volts of live current and a capacitor holding enough charge to knock you off a ladder even with the power off. A capacitor doesn’t discharge just because you pulled the disconnect. If you don’t have the training and the right discharge tool, that’s a hospital trip waiting to happen. We’re not saying that to scare you. We’re saying it because every year someone in Cobb County tries it and learns the same lesson the hard way.

If you’ve already checked the thermostat and breaker and you still have a problem, call us at (229) 514-0545. We’ll get a live person on the phone, schedule a visit, and give you a live arrival time so you’re not sitting around for a four-hour window. We’ll also tell you the service call cost before we roll a truck to your door.

FAQs

Need HVAC help in Marietta? Licensed & insured · same-day response · free estimates
Call (229) 514-0545
Local Service Coverage

Request a Free Estimate in Marietta

Tell us what you need - Halden Heating and Air Marietta responds fast. No obligation.

By clicking submit, you agree to our Privacy Policy and agree to be contacted through phone, text, or email regarding your project, including by the service partners who may complete the work.

Prefer to text? Text Us
Call Now - 24/7 Dispatch